Unlock Samsung Washer Door After Putting New Lock

1 press the start pause button to unlock the door.

Unlock samsung washer door after putting new lock.

You can try and open the door on the bottom right on the front of the machine. Also note that it takes atleast a minute or two until the indicator stops blinking. Reconnect power to washer plug in. If you get stuck though you can drain the water from front load washers using the emergency drain hose.

If you re in the middle of a cycle turn the dial or press the button to pause or end the cycle. Press and hold the temp and spin rinse buttons for three seconds. In this case wait until the indicator stops blinking. Child lock also will lock the door on some models like front loaders.

Press and hold the temp and spin buttons for three seconds. It may take a few minutes for the washing machine to cool down and for the lock to release. If it doesn t turn the machine off by pressing the button or turning the dial all of the way to the off position. If the water level or the water temperature inside the drum is too high the door can not be opened with the blinking door lock indicator.

Samsung washer door is locked your washer door locks to prevent water from coming out especially for front load models. How to fix locked samsung washing machine door fix. Normally waiting for the cycle to end is all you need to do to unlock the door or turn your washer on if it s off. You will find a small black hose with a plastic plug in the end of it.

If you get stuck though you can drain the water from front load washers using the emergency drain hose. Wait 5 6 seconds to see if the door unlocks. Turn the washing machine off and unplug it. Child lock also will lock the door on some models like front loaders.

The most common ways to activate and deactivate child lock are. If the panel has no tab to pull down on carefully use a flat head screwdriver and gently pop the panel open. If the door remains locked when the cycle is finished push start pause to clear the lock. Once you have the panel open find the small rubber drain hose.

The door should unlock after this is complete. Pop open the panel on the debris filter press down on the small tab on the panel and pull the panel downward. Wait approximately 2 minutes for control to reset. If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.

Once the water is gone the door will unlock. Once the water is gone the door will unlock. Run a drain and spin cycle. Press and hold the and buttons for three seconds.