If you need to cut the rebar to size with a metal cutting hacksaw blade or another saw.
Tying concrete walls together.
Thank you for all your support https www paypal me mountainhomestead essential.
Place a layer of steel rebar of the way up the hole.
Fill the hole with epoxy slowly.
Lay the rebar in a grid with the bars spaced about 12 in 30 cm apart.
Use rebar about 1 3 in 0 85 cm in diameter to reinforce the concrete.
If the joint is wider than it is tall place the holes horizontally.
Snap tie concrete forms are a simple and easy system for foundation walls.
Pull the tip of the gun out of the hole as it fills.
Make these holes 12 inches on center horizontally or vertically depending upon the predominant orientation of the joint.
This tie is made by going about 1 1 2 times around the vertical bar then diagonally around the intersection twisting the two ends together until the connection is tight but without breaking the tie wire then cutting off the excess.
This will provide lateral support to the wall but will allow some minor vertical movement without cracking.
If the joint is taller than wide place the holes vertically.
Insert the tip of the epoxy gun into the hole as far as you can.
This tie is used mostly on floor slabs.
The wall tie is used on light vertical mats of steel.
Provide a bond breaker on each leg of the angle and break out the end webs of the new blocks.